Ets2 multimon no eyefinity12/11/2022 So, since I had been attempting to get Softth to work for hours without progress at this point, as well as attempting it for hours with 2 monitors before, I gave up on my dream of 3-screen wide with similar heights. The actual screenshot when using Softth on 4162x1440 What my monitors show when using Softth, the white lines resemble the monitor borders Ets2 multimon no eyefinity full#I made a quick paint3D masterpiece to show it for you, though keep in mind that when I take a screenshot the second pic is what it saves, so ets2 doesn't seem to recognize the full resolution, even though I had set it to 4962x1440 in the settings, and the Softth logo was shown on both side monitors. So I started by attempting to do this in Softth, and when I then start ets2 only the main screen is shown, but pushed all the way to the left. With _Softth I was using multimon mode 1, and with eyefinity mostly 1 but testing it with 2 as well. I got the Philips monitor new last Christmas, while the other 2 probably are relatively old, the Samsung one looking pretty old too. My 3 screnns are a Philips BDM3270 monitor in the middle (2560x1440), a Samsung SyncMaterB1940 monitor on the left and an unknown Dell monitor on the right (both 1024x1280). Ets2 multimon no eyefinity Pc#I have a PC with Windows 10, an i5 6600k and an AMD R7 360. This also means I can't use AMD eyefinity due to it not supporting portrait and landscape modes mixed in a setup. I want to use Softth for the simple reason that these are office monitors that are as wide as my main monitor is tall, so I use them in portrait to make the 3 monitors match in height. Ets2 multimon no eyefinity how to#Has anyone figured out how to get this output from stdout into another program? I am wondering if this is related to the thread about not getting input properly when using tee? There is also the dsame project that will decode the EAS string into the readable text and the examples use multimon-ng as an input.but that does not work for me either (since I get no output).So I recently got a second monitor (from a pile of unused ones) and was trying to get dualmonitor to work for hours until I gave up and brought home a third. I have tried every solution I can think of, including python subprocesses suggested in a similar thread but nothing works. If I redirect ONLY stderr, I see ONLY that one line in stdout (the rest is written to stderr and thus ends up in the file). As you can see, when I run the application normally, I see that line. I have attached a few screenshots to depict this. After working through some examples, I discovered anytime I redirect, I no longer see the line "Enabled demodulators: EAS" when mulitmon-ng starts. Any time I try to redirect stdout I get no output at all from multimon-ng. However, I cannot seem to capture this output outside of stdout. However, I would like to take the output from multimong-ng and pipe that EAS message into another application. When multimon-ng outputs directly to stderr and stdout, everything is working perfectly. I am using rtl_fm and a dongle along with multimon-ng to demodulate EAS messages. I am working on an SDR project on a Raspberry Pi3 B+ and have recently gotten stuck.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |